Finn-Power Bedieningen

MS Control

In MS models, the diameter is set using a 10-turn vernier dial. One turn is equivalent to a 1 mm change in crimping diameter. The diameter can be set with an accuracy of 0.01 mm.

MS Control device	Instelling MS Control

 

---

IS Control

IS control is an analogical control which features easy stepless adjustment of crimping diameter. Potentiometers are used for setting both crimping and retraction diameters.

IS control is a user-friendly, reliable solution for crimping control. Manual, semi-automatic or automatic control modes can be selected. Mode selector offers also crimping delay which occurs after the crimping diameter has been reached.

IS Control used in C1 control units

IS Control used in C2 control units

 

 

IS Control used in P models

IS Control used in NC and CC models

 

---

VS Control

VS Control is a modern user interface based on icons, a selector and clear, visual indication of all crimping parameters. When the required crimping diameter is given, the interactive VS automatically recommends a die set among those stored in its tool management memory.

Crimping parameters are specified at a tolerance of 0.1 mm. Fine adjustment can be done at a tolerance of 0.01 mm. Up to 200 combinations of retraction diameter/ correction requirements/ crimping diameter/ die set/ delay adjustment, can be stored for immediate availability.

VS Control makes set-up change a simple matter of seconds. For example, its gives step-by-step instruction for die set change. This means additional flexibillity in the manufacturing of short, repeatable series.

VS Control used in C1 control units

VS Control used in C2 control units

VS Control used in P models

VS Control used in NC and CC models

---

FINN-POWER provides crimping capacity for most varied applications and production types. To ensure that specific application requirements are met, alternative control types are available. 

More information: CONTROLS